Thank you for the video it was very informative. If I may,I would like to ask a few questions. Firstly, will this unit run on a 15 amp circuit or is a 20 amp recommended? Is it difficult to find carbide cutters for this planer? I am hoping to find a planer that that will plane hard curly maple which is kiln dried. I tried to do this with my Ridged 3 blade planer and totally destroyed the surface of one side of the board with chip outs. I adjusted my planer to remove 1/32nd. of an inch with relatively new cutters and I am shocked to see the results. Will I get much better results with the Laguana PX12? I know that I should dampen the wood somewhat but up here in Canada the water would turn to ice probably before I could get back into the garage.lol
Thank you for the video it was very informative. If I may,I would like to ask a few questions. Firstly, will this unit run on a 15 amp circuit or is a 20 amp recommended? Is it difficult to find carbide cutters for this planer? I am hoping to find a planer that that will plane hard curly maple which is kiln dried. I tried to do this with my Ridged 3 blade planer and totally destroyed the surface of one side of the board with chip outs. I adjusted my planer to remove 1/32nd. of an inch with relatively new cutters and I am shocked to see the results. Will I get much better results with the Laguana PX12? I know that I should dampen the wood somewhat but up here in Canada the water would turn to ice probably before I could get back into the garage.lol